R-10 magnets provide the intense, short throw field that's ideal for the job of moving plate stock positively, speedily and cost effectively. They are built to the highest specification, Bring R-10 magnets into use and you'll get no more plate edge damage from grabs. No more distorted bending, since plates are fully supported.
No more stack spacers, so stock takes up less space, and they save labour as well because assistance is not required with ground handling gear.
Available in a range of sizes, either singly or as multiple units mounted on a spreader beam, R-10 magnets embody all the latest features in magnet design and construction.
The substantial body casting is made from high permeability steel, and coil enclosures are of austenitic steel and are welded in position to form a water tight seal.
Fabricated steel can be used to customer preference and for special designs.
The coils themselves are made from high conductivity copper or aluminium conductor wound round a single pole to prevent deadspots, and they are insulated up to Class H standards using mica based material.
The entire magnets are finally vacuum dried and filled with a high temperature silicone elastomer to prevent moisture ingress or the formation of internal condensation.
MATCHED PRECISELY TO YOUR NEEDS...
R10 magnets offer the user a choice of sizes and application arrangements. They can be used singly for small plates or in multiples mounted on a spreader beam.
The number of magnets required for any particular application is governed by the thickness of the plate, whereas the size of the magnets depends on the weight of the plate.
|
